Country or region and language

    Choose your country or region and your language.

    Suggested for you

      All countries and regions

        Choose your character

        It shows in the top bar and on your profile. Change it any time.

        Networking course

        CLI and interface inventory

        Opening Networking
        Your turn

        Cisco-style CLI commands and inspection reference

        The table covers the IOS-like syntax implemented by this independent teaching simulator. It is a practice reference, not an exhaustive Cisco IOS command list. Real command support depends on the device and software release. Consult Cisco’s command reference before using a command on hardware.

        Inspection commands

        Command Use in this simulator
        show ip interface brief Inspect addresses and interface state
        show vlan brief Inspect VLANs and access-port membership
        show interfaces trunk Inspect trunk, native VLAN and allowed VLANs
        show ip route Inspect connected and configured routes
        show ip ospf neighbor Inspect simulated OSPF neighbors
        show access-lists Inspect ACL entries
        show running-config Inspect the current device state

        Command modes

        enable enters privileged mode. configure terminal enters global configuration. An interface Gi0/1 command then selects an interface. exit moves back one level, while end returns to privileged mode.

        An interface example, using fictional documentation space:

        enable
        configure terminal
        interface Gi0/1
        ip address 192.0.2.65 255.255.255.224
        no shutdown
        end
        show ip interface brief

        Read the final output. The address, mask and administrative state must all match the task. Saving an incorrect configuration does not repair it. In this simulator, copy running-config startup-config saves the current state; the lesson decides whether saving is required.

        Troubleshooting order

        Inspect the interface first, then its VLAN and route context. Use ping or traceroute for the specific destination the task names. A successful test to a neighboring router does not prove that a remote subnet is reachable. Change one cause and inspect the state again.

        Continue with subnetting practice or the CCNA practice guide.

        Your Work Gym account

        Save your progress and pick up on another device. Your browser's progress comes with you.

        or

        You can keep practicing without an account.

        Change your plan

        Checking the price

        Help and feedback

        Ask a question, tell us what is not working, or share an idea. We reply by email.

        What is it about?

        We use it only to reply to you.